Computer engraving machine installation process

Computer engraving machine installation process
For computer engraving machine, in the installation of the time we need to comply with a certain installation process, for the convenience of the operation, we will be the process for all listed.
First of all, we use the supplied power cable to connect the carving machine and a power socket and then using a communication cable to the engraving machine is connected with a computer, after the power is turned on, or drawing pen carved into the moment the knife the knife.
Then we need to place the corresponding medium, general computer engraving machine, the applicable material have reflective film, instant stickers, wall stickers, body film, stickers, paper and kraft paper, at the same time set the parameters, including the origin of the coordinate, the knife or the pen speed and so on.
Followed by our computer engraving machine can be normally carved, first of all we can try engraved, in normal use, computer data transmission the start carving or is drawing at the same time, we should pay attention to, in our lettering machine after the shutdown and start again when the time interval shall not be less than 30 seconds.
In fact, the installation and operation of engraving and milling machine will be random with the corresponding operation manual, we only need to strictly follow the normal use of the steps to carry out the operation, to ensure its normal operation.
Article by the mold engraving machine manufacturers to provide, reproduced please specify http://www.huadiao.cn/jishu/dndkjdazlc.htm