Maintenance method for the maintenance of the spindle motor of the woodworking engraving machine

The spindle motor is an important part of the woodworking engraving machine, and is one of the more vulnerable parts. So, usually need to pay attention to the maintenance and maintenance, to ensure the normal operation and to extend its service life. Maintenance method for the maintenance of the spindle motor of the woodworking engraving machine:
1, master the operation of the spindle motor.
2, the establishment of a good care of the consciousness, forming the end of processing to clean up the habit of spindle motor.
3, keep the air of the electric spindle dry clean.
4, the daily cleaning of the spindle motor, need to remove the electric spindle from the engraving machine, and then use the trachea to the main shaft of the cooling chamber of the residual water, to keep the internal clean. In the short term, the surface of the electric spindle can be coated with anti rust oil, and the shaft end and protective device is kept in the dry place.
5, is not used for a long time and need to seal the electric spindle, restart, in addition to gasoline to clean the surface of the oil and rust, also need to do the following work:
Oil mist 3-5min. Then twist the shaft with the hand, ask for no card.
Check insulation with Ohm meter.
The power supply is switched on, idling, no abnormal.
According to the spindle speed is different, choose different grease, high speed grease or oil mist lubrication.